Hensel-Visit Nova D 1200, Руководство пользователя

Страница: 31 / 64

Operating the device
31
Activating and deactivating the model light
“Full” and “Prop” modes
To activate the model light in the “Full” and “Prop” modes, proceed as
follows:

Briefly press the LAMP button. The “Prop” LED display above the LAMP
button illuminates as green.
The brightness of the model light is proportional to the set flash energy.

Press the LAMP button again.
The “Full” LED display above the LAMP button illuminates as green. The
model light illuminates at maximum brightness, irrespective of the set flash
energy.
To deactivate the model light in the “Full” and “Prop” modes, proceed as
follows:

Press the LAMP button again.
The “Full” and “Prop” LED displays above the LAMP button go out.
Activating and deactivating automatic model light
reduction (“Autored”)
The device is equipped with an automatic model light economy mode
(“Autored”). After a preset time of 35 minutes, the brightness is dimmed to
half (level 9) in “Full” mode. In “Prop” mode, the brightness is reduced to
half when the flash energy is set in a range from 9.1 to 10. To activate
automatic model light economy mode (“Autored”), proceed as follows:

Press the arrow buttons (2, 3) at the same time.
The last selected switchover time is shown in minutes on the right display.

Press the arrow buttons (2, 3) to adjust the time in one-minute
increments up to a maximum of 90 minutes.

Press the arrow buttons (1, 4) to adjust the time in 5-minute
increments.