Henny Penny OFG-390, Руководство оператора

Страница: 46 / 51

Model OFG- 390
4-2. ERROR CODES (Continued)
CE Only - Along with the error codes from page 4-2, CE
units have the following self-diagnostic error codes:
DISPLAY CAUSE PANEL BOARD CORRECTION
“E10” High limit Reset the high limit by manually pushing up on the red reset
button; if the high limit does not reset, the high limit must be
replaced
“E15” Drain switch Close the drain, using the drain valve handle; if display still
shows “E-15”, have the drain microswitch checked
“E-20 A” Air pressure Press the timer button to try the ignition process again,
switch failure and if “E-20 A” persists, call Henny Penny’s Service
(stuck closed) Department
“E-20 B” Draft fan or Press the timer button to try the ignition process again,
air pressure and if “E-20 B” persists, call Henny Penny’s Service
switch failure Department
(stuck open)
“E-20 C” Left gas module Press the timer button to try the ignition process again, and if
failure “E-20 C” persists, call Henny Penny’s Service Department
“E20 D” Right module Press the timer button to try the ignition process again, and if
failure “E-20 D”, persists, call Henny Penny’s Service Department
“E20 E” Both modules Press the timer button to try the ignition process again, and if
failure “E-20 E”, persists, call Henny Penny’s Service Department
“E20 F” Left module Press the timer button to try the ignition process again, and if
no flame sense “E-20 F”, persists, call Henny Penny’s Service Department
“E20 G” Right module Press the timer button to try the ignition process again, and if
no flame sense “E-20 G”, persists, call Henny Penny’s Service Department
“E20 H” Both modules Press the timer button to try the ignition process again, and if
no flame sense “E-20 H”, persists, call Henny Penny’s Service Department
4-3 303