Model HCH-930/932
2-8. FLOAT SWITCH
1. Disconnect the electrical supply to the cabinet.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit breaker,
or unplug cord at wall receptacle.
2. Remove the cabinet top.
3. Remove the float switch wire from the L1 wire nut, and check for
continuity across this wire and terminal 3 of the solid state relay.
With the float in the raised position, the circuit should be open.
With the float in the lowered position, the circuit should be closed.
If the float is not defective, reconnect the float switch wire to the
L1 wire nut. If it proves defective, continue with the steps below.
4. Cut the float switch wire that attaches to terminal 3 on the solid
state relay.
5. Remove the 2 screws securing the float switch well and pull the
well up and out of the heater box cover.
6. Remove the nut securing the float switch in the well and remove
the old float switch. Save the 2 spacers removed with the float
Step 5
switch.
7. Install new float switch using the 2 white spacers from step 6.
Tighten the float switch nut finger tight only! Over-
tightening the nut damages the float switch.
8. Reinstall the float switch well.
Step 6
9. Strip the end of the cut wire from step 4, and attach it to one of
the new float switch wires, using a wire nut.
10. Connect the other float switch wire to the L1 wire nut.
11. Replace the cabinet top.
12. Reconnect the electrical supply to the cabinet.
203
2-5
Содержание HCH-930
