Henny Penny Evolution Elite EEG-16 Series, Техническое руководство

Страница: 63 / 98

Maintenance
51
7 7))
Turn on blower and verify that pressure is 1.7 inwc at 60 Hz (1.4 inwc at 50 Hz)
or greater.
If less than 1.7 inwc at 60 Hz (1.4 inwc at 50 Hz) verify the flue is not obstructed then
continue to “WHEEL REPLACEMENT”.
6 6..1 12 2 B Bllo ow we err R Re ep plla acce em me en ntt
W WA AR RN NIIN NG G!! S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all ssh ho occkk o orr p prro op pe errttyy d da am ma ag ge e,,
m mo ovve e tth he e p po ow we err ssw wiittcch h tto o O OF FF F a an nd d d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un np pllu ug g
cco orrd d a att w wa allll rre ecce ep ptta acclle e..
1 1))
Remove electrical power supplied to the unit.
2 2))
Remove the lower back shroud.
3 3))
Using a crosshead screw, remove the two screws that secures the blower to the
flue. One screw is located on the back side of the flue.
4 4))
Cut zip ties that are holding the wires to the blower. Remove the wire nuts from
the wires.
5 5))
Remove blower (refer to 6.12 Blower Replacement, page 51 ).
6 6))
Reconnect new blower wires to the existing wires with wire nuts.
7 7))
Tighten the new blower onto the flue with the two screws.
8 8))
Zip tie wires back to the blower.