Henny Penny Evolution Elite EEG-16 Series, Техническое руководство

Страница: 38 / 98

Level
2
Programming
26
2 2))
Press the up or down arrow to choose “SPLIT” or “FULL”.
5 5..1 1..2 21 1 S SP P--2 21 1 A Au utto o--L Liifftt E En na ab blle ed d
1 1))
Press and release the right arrow until “SP-21 AUTOLIFT ENABLED?” flashes
in the left display.
2 2))
Press the up or down arrow to choose “YES LIFT” or “NO LIFT”.
3 3))
If fryer is fitted with the auto-lift option, SP-21 must be set to “YES LIFT”,
otherwise, set SP-21 to “NO LIFT”.
5 5..1 1..2 22 2 S SP P--2 22 2 B Bu ullkk O Oiill S Su up pp pllyy
1 1))
Press and release the right arrow until “SP-22 BULK OIL SUPPLY?” flashes in
the left display.
2 2))
Press the up or down arrow to choose “YES SUPL” or “NO SUPL”.
3 3))
Set to “YES” if the oil is pumped into the vat from an outside oil reservoir.
Otherwise, set SP-22 to “NO”.
5 5..1 1..2 23 3 S SP P--2 23 3 B Bu ullkk O Oiill D Diissp po ossa all
1 1))
Press and release the right arrow until “SP-23 BULK OIL DISPOSE?” flashes in
the left display.
2 2))
Press the up or down arrow to choose “YES DISP” or “NO DISP”.
3 3))
Set to “YES DISP” if the oil is pumped from the vats to an outside oil reservoir
when discarding the oil. Otherwise, set SP-23 to “NO DISP”.
5 5..1 1..2 24 4 S SP P--2 24 4 S Se erriia all N Nu um mb be err L Lo og g
1 1))
Press and release the right arrow until “SP-24 S/N ✓EDIT” flashes in the
displays, along with the serial number of the unit.
NOTE: This serial number should match the serial number on the data plate, on the
doors. If not, it can be recorded.
5 5..1 1..2 25 5 S SP P--2 25 5 P Prro og grra am m C Co od de e C Ch ha an ng ge e
This allows the operator to change the program code (factory set at 1, 2, 3) used to
access Product Programming and Level 2 Program Mode.
1 1))
Press and release the right arrow until “SP-25 CHANGE MGR CODE? 1=YES”
flashes in the display.
2 2))
Press product button 1 and “ENTER NEW CODE, P=DONE, I=QUIT” scrolls
through the display. Press the product buttons for new code.
3 3))
If satisfied with the code, press the program button and “REPEAT NEW CODE,
P=DONE, I=QUIT” shows in display. Enter the same code you previously
entered.
4 4))
If satisfied with code, press the program button and “CODE CHANGED*” shows
in display.
5 5))
If not satisfied with code, press the info button and “*CANCEL*” shows in
display, then reverts back to “SP-25” “CHANGE MGR CODE? 1=YES”. Now the
above steps can be repeated.