15
5.7 Set: Time (Auto) Mode
Set the dispensing time for Channel A and Channel B in “Run: Auto” mode.
1. Press
to select Channel A, the left most digit for Channel A will start to flash.
2. Press
for numbering change on the flashing digit (0.01
–
99.99).
3. Press
to move the flashing digit 1 digit to right.
4. Press
again to switch from Channel A and Channel B.
5. Repeat steps 2 & 3.
6. After completed setting, press
to save and exit.
5.8 Set: Delay (Auto) Mode
Set the delay time of Channel A and Channel B after activating the footswitch in
“Run: Auto” mode.
1. Press
to select Channel A, the left most digit for Channel A will start to flash.
2. Press
for numbering change on the flashing digit (0.01
–
99.99).
3. Press
to move the flashing digit 1 digit to right.
4. Press
again to switch from Channel A and Channel B.
5. Repeat steps 2 &3.
6. After completed setting, press
to save and exit.
5.9 Set: Output Mode
Enable or Disable the output for each channel. Each channel will only operate if the
Output is ‘enabled’.
1. Press
to select Channel A, Output mode will start to flash.
2. Press
to switch between “ON” or “OFF”.
3. Press
again to switch from Channel A to Channel B.
4. Press
to switch between “ON” or “OFF” for Channel B.
5. After completed setting, press
to save and exit.
