Hendi 289952, Руководство пользователя

Страница: 22 / 80

22
EN
6. Place the connected elements in the grain
basket and put it in the body.
7. After adding water and ingredients, remove
the grain stopper and the screw nut 3.
8. Install the top sparge plate with the handles
facing up on the telescopic overflow pipe.
9. Now it is ready for circulation.
Program setting
NOTE:
To restore factory settings in memo-
ry function for both auto and manual modes,
press and hold the
AUTO
PAUSE
button for 5 seconds in
standby mode, as shown below (only the current
temperature is shown on the display). A slower
bell sounds confirms this operation.
MANUAL
PAUSE
AUTO
PAUSE
A1. MANUAL MODE SETTINGS
1. Turn the power on and then press the
MANUAL
PAUSE
button.
2. Use the button to set the temperature,
button to set the power and the but-
ton to set the process timer – all 3 parame-
ters have to be configured to start the device.
You can configure them in any order.
3. Once all 3 parameters have been configured,
press the button to activate manual mode.
The flashing “H“ letter in the top left corner
means the device has begun heating up.
4. The pre-programmed default boiling tempera-
ture is 100°C, and the Timer will not start be-
fore the temperature reaches 100°C. To do that
cover with a lid for 1-2 minutes for the display
to reach 100°C.
5. When the device begins boiling, but a lower
temperature is displayed, perform the fol-
lowing temperature configuration to set the
temperature to 100°C and start the Timer.
6. Press the and buttons simultane-
ously until C1/F1 appears on the display. The
temperature can be adjusted by between –
10°C and +10°C or – 50°F to +50°F.
7. Press the
MANUAL
PAUSE
button during the heating
process to restore the device to its initial set-
tings. Then the temperature, power and tim-
er settings can be changes. Press the
MANUAL
PAUSE
button to continue heating up.
8. To change the temperature units from Cel-
sius to Fahrenheit press and hold the
button for 5 seconds. This stetting can be
changed only directly after the device is
turned on, before changing any other param-
eters.
A2. MEMORY FUNCTION IN MANUAL MODE
1. Press and hold the
MANUAL
PAUSE
button for 5 seconds
in manual mode and then release. This will
store the last settings to the memory. A bell
will sound once the most recent settings
have been saved to memory.
2. Press the button after performing the
above sequence and the device will be ready
to be used according to the most recently
saved parameters.
3. Press the button to stop the device.