Helvi UNITECH 328, Инструкция по эксплуатации

Страница: 3 / 48

III
TROL PANEL EN-10
FIGURE 12 - UNITECH 418-558 CONTROL PANEL EN-12
FIGURE 13 - GAS TEST / WIRE FEEDING BUTTONS EN-12
INITIAL SETUP MENU EN-13
MIG WIRE WELDING EN-14
2T/4T MODE EN-14
INDUCTANCE EN-14
PARAMETERS DISPLAYING EN-14
MANUAL MIG WELDING (JOB LIST 10) EN-14
SYNERGIC MIG WELDING (JOB LIST 11-99) EN-14
RADID SETUP MENU - MIG EN-14
TABLE 2 EN-14
“CONSTANT VOLTAGE” FUNCTION EN-14
MMA WELDING EN-15
MMA MODE (UNITECH 328-358C - X4 WIRE
FEEDER) EN-15
MMA MODE (UNITECH 418-558
GENERATORS) EN-15
TIG WELDING EN-15
TIG MODE (UNITECH 328-358C -
X4 WIRE FEEDER) EN-15
TIG MODE (UNITECH 418-558) EN-15
SAVE AND RECALL (MIG ONLY) EN-16
SAVE EN-16
RECALL EN-16
FACTORY RESET EN-16
UNITECH 328-358C- X4 WIRE FEEDER EN-16
UNITECH 418-558 EN-16
PROTECTION GASES GUIDE EN-16
TABLE 3 EN-16
WELDING HINTS AND MAINTENANCE EN-17
ERRORS LIST AND TROUBLESHOOTING EN-17
ERRORS LITS EN-17
TROUBLESHOOTING EN-18