Now attach the
Connector clips
to each end of the strap. Clip the top
clip to either the
Soft
“O” Ring
or up to
Shoulder “D” ring.
See
#3
to connect to the shoulder “D” ring.
The device is an
Anti-Rotation Strap
and
Two Connector Clips.
First pass the strap through the two elastic bands on the “T” Pad [under the
chest].
Now
attach the connector clips to either end of the strap. These clips allow you to connect the strap to either the chest
“O”
Ring or
Shoulder
“D”
ring and finally, to the
“D”
ring on
Hip Lift.
Note:
You can leave it connected even when you remove the harness.
Connect the strap to the
Shoulder “D” ring.
Make sure this strap
is attached to the
opposite side
of the missing limb.
Finally attach the
Rear Connector Clip
to the hip lift
“D” ring.
Now
make adjustments to the strap length. Make it snug but not too
tight. A small amount of drag keeps the harness from spinning.
First pass the
Anti-Rotation Strap
through one or both of the two
elastic bands.
#1
[shown above] on the bottom of the T-Pad and
#2
at the top of the chest pad strap [shown in frame #2].
1
2
3
4
The Anti-Rotation strap connects to the Hip Lift
at the opposite side of the front amputation.
[as shown here].
For
Front
Amputees
Also watch our fitting demonstration at www.helpemup.com/videos
Blue Dog Designs
720-237-6852
www
.
helpemup.com
Anti-Rotation Strap
The Anti-Rotation strap connects
on the same side as the rear
amputation [shown here].
Note:
It can be
left connected
whenever you
remove the
harness.
For
Rear
Amputees
Anti-Rotation Strap
Hip Lift
Connector Clip
Rear Connector Clip
Connect Clip to “O” Ring or Shoulder “D” ring
Soft “O” Ring
Elastic Band #1
Anti-Rotation Strap
Upper shoulder “D” ring
Elastic Band #2
Connect here to “D” ring
Pass under Elastic Bands 1#2
Deuce, 9
Connect Clip to Hip lift “D” ring
Hip Lift “D” ring
Shoulder “D” ring