TOADINATOR and ACTA ATTRACTA INSTRUCTIONS
ANIMAL CONTROL TECHNOLOGIES (AUSTRALIA) PTY LTD
46 - 50 FREIGHT DRIVE, SOMERTON, VICTORIA 3062, AUSTRALIA
TELEPHONE: +61 (0)3 9308 9688 FACSIMILE: +61 (0)3 9308 9622
IMPORTANT
Make sure to charge your Attracta in a wall charger and charge for a
minimum of 12 hours before use and before charging with the solar panel
ACTA ATTRACTA SETUP
1.
Power On/Off
Open the waterproof plug at the back of the Attracta unit and locate the round
power button.
To power ‘on’, hold the button for at least 3 seconds and it will sound “power on”
whilst the UV light blinks 3 times.
To power ‘off’, hold the button for at least 3 seconds and it will sound “power off”
whilst the UV light blinks 3 times.
2.
Changing the Volume
You can see the two buttons at the back of the Attracta unit, press the button
+
or
-
to increase or decrease the volume *
* It will only sound when the unit is in the dark or the light sensor is covered.
3.
Selecting Sounds
Four (4) sound files are pre-loaded to the unit. You can switch to the next sound file
by pressing the power button once quickly when the unit is powered on. The
selected sound file will loop play automatically *
* It will only sound when the unit is in the dark or the light sensor is covered.
4.
Charging using A/C Power
Connect A/C power adaptor to the Attractor unit by matching the male and female
connectors and then firmly screw the O-ring gasket over the connection.
Input: 100-240V~, 50/60Hz 0-3A / Output: 5V == 100mA
