HellermannTyton Autotool System 3080, Руководство по эксплуатации, Страница: 12 / 28

Operating Instructions • ATS3080 • 02-2017 • v01 • 102-01002
Operation
12
5 3 Assemble jaws
Required tool
• Screwdriver 2 mm Allen screw
Assemble jaws
2
1
3
4
f Select the jaws suitable for the bundle, à "Geometries
of bundles" on page 14
f Loosen the screws
1
and
4
.
f Push the upper jaw
2
and the lower jaw
3
into the
respective jaw receivers until they engage.
f Pay attention to the labelling and the correct assignment
of the upper and lower jaw.
NOTE
The screw heads do not rest on the housing.
f Do not tighten the screws up until the stop.
f
Tighten screws
1
and
4
and by doing so clamp the
jaws.
5 4 ATS3080 connect
1 2
f Connect power pack 3080
2
to power-supply outlet
1
.
NOTE
The power-supply outlet must be readily accessible so that
the system can be de-energised if the need arises.
I
0
Power
Signal
ATS
308
0 Po
wer
Pack
2
3
1
f Connect the ATS3080
3
with the connecting cable
2
to
the power pack 3080
1
.
; The locking rings of the connecting cable
2
engage.
6 Operation
6 1 Load tie heads
2 1
f Insert the closure chain
1
with the number facing
towards the front and upwards.
f
Open the cover
2
of the ATS3080.
f
Insert closure chain
1
up to the first point.
; The LED 4 Lock material in the display goes out.
; The closure chain
1
locks firmly into place.
f Close the cover
2
.
6 2 Load tie ribbon
2
1
3
f Ensure that the tie ribbon
1
is cut at a right angle.
; The tie ribbon is at least 12 cm long.
f Press the red button
3
of the roller block
2
and hold
down briefly for adjustment.