TT4000 Series
Operating Instruction
18
For use in Tear-Off mode only:
⇒
Turn lever (Figure 4, Pos 9) clockwise to lock the print head. The label roll is loaded for
use in Tear-Off mode.
If continuous material without any label gaps or sensor punchings are used (i.e. continuous
shrinking sleeve), then position the label sensor with tab (3) approximately to the center of
the material.
6.1.4
Winding up the label strip in Rewind mode (optional)
Figure 6
Guiding the label strip in Rewind mode (optional)
In Rewind mode, the labels are wound up internally after printing for later use.
1.
Remove the locking system for Rewind mode if necessary (see 6.7 on page 25) and
install rewind guide plate (see 6.6 on page 24).
2.
Guide label strip around the rewind guide plate (4) to the internal rewinder (2).
3.
Hold rewinder (2) firmly and turn knob (3) clockwise until it stops.
4.
Push label strip under a bracket (1) of the rewinder and turn knob (3) anti clockwise
until it stops. The rewinder is fully spread, thus gripping the label strip firmly.
5.
Turn rewinder (2) anti clockwise to tighten the label strip.
6.
Turn lever (5) clockwise to lock the print head.
The label roll is loaded for use in Rewind mode.
