11
1
101375
Injector Cap
1
2
102159
O-ring 135
1
3
102457
Injector Screen
1
4
102319
Injector Assy. Z Plug-Filter
1
5
101825
Injector Assy. A Black
1
101826
Injector Assy. B Brown
101827
Injector Assy. C Violet
101828
Injector Assy. D Red
101829
Injector Assy. E White
101830
Injector Assy. F Blue
101831
Injector Assy. G Yellow
101832
Injector Assy. H Green
101833
Injector Assy. I Orange
101834
Injector Assy. J Light Blue
101835
Injector Assy K Light Green
Not Shown 106767
O-ring 011
*
Not Shown 106768
O-ring 013
*
QTY.
ITEM NO. ORDER NO.
DESCRIPTION
INJECTOR CAP, INJECTOR SCREEN, INJECTOR, PLUG AND O-RING
* The injector plug and the injector each contain one 011 (lower) and 013
(upper) o-ring.
Note: For upflow position, injector is located in the up hole and injector
plug in the down hole. For a filter that only backwashes injector plugs are
located in both holes.
The nuts and caps are designed to be unscrewed or tightened by hand or with the special plastic wrench. If necessary a pliers can be used to unscrew the nut
or cap. Do not use a pipe wrench to tighten or loosen nuts or caps. Do not place screwdriver in slots on caps and/or tap with a hammer.
Do not use pipe dope or other sealants on threads. Teflon tape must be used on threads of the 1” NPT connection and on the threads for the drain line connection.
Teflon tape is not necessary on the nut connection nor caps because of o-rings seals.
Figure 10
REFILL AND REFILL PORT PLUG
Figure 11
**This part is required
for backwash only
systems.
5
6
4
2
1
ITEM NO. ORDER NO. DESCRIPTION
QTY
1
102322
Refill Port Plug Assy
1
2
101414
Elbow Locking Clip
1
4
110822
Elbow, 3/8 Assy
(Includes Check Valve & Nut)
1
5
102153
O-Ring 019
1
7
111004
Tubing 3/8"
1
8
111006
Polytube Insert 5/16"
1
4
7
8
From Generator
