HELIX S.R. SMITH, Инструкция по сборке и установке

Страница: 9 / 18

9
9) Lay the ladder assembly on the ground with the steps facing down as shown in Figure 8. Lift
the upper runway section and align the threaded studs sticking out of the top ladder section
with the holes in the upper runway section. Attach the runway to the ladder using the
hardware shown in Figure 8. Tighten until the lock washer is fully compressed. Notes: It
may take more than one person to perform this step. Verify that the gasket material is
properly attached before assembling the parts. Be sure to apply anti-seize to all
fasteners to prevent galling.
10) Apply a .25 inch bead of Silicone sealant (Silicone II or similar) around the base of the cone
of the slide’s center column. See Figure 9.
(4)
(1) (2)
Figure 8
APPLY .25” BEAD OF SILICONE
Figure 9