HELIX S.R. SMITH, Инструкция по сборке и установке

Страница: 10 / 18

10
(2)
(4)
(9)
(26)
11) Stand the ladder upright and attach the runway entrance section to the runway exit section
using the button head cap screw as shown in Figure 10 through the slides center column. Do
not tighten the bolt at this point. Notes: It may take more than one person to perform this
step. Be sure to apply anti-seize to all fasteners to prevent galling.
12) Finish assembling the two runway sections using the hardware shown in Figure 11. Note:
Be sure to apply anti-seize to all fasteners to prevent galling.
a. First, the 2” Hex Head Tap Bolt (Item 13) should started into the threaded insert; do not
tighten at this point.
b. Install the 5” Button Head screw (Item 9) into the outside rail, and fully tighten.
c. Install the hex bolts (Items 10) through the underside of the run way.
d. Go through and tighten all of the hardware installed in steps 11and 12.
Figure 10