Heinner HWM-H7012SE+++, Руководство пользователя

Страница: 29 / 69

www.heinner.com 7Kg, 220-240V~50Hz, 1200rpm
28
X. TROUBLESHOOTING
Depending on the model, your washing machine is equipped with various automatic safety
functions. This enables faults to be detected in good time and the safety system can then
react appropriately. These faults are frequently so minor that they can be resolved within a
few minutes.
The washing machine will not start, no indicator lamps are on.
Check whether:
•
the mains plug is inserted into the socket.
•
the wall socket is functioning correctly (use a table lamp or similar appliance to
test it).
The washing machine will not start... and the "Start/Pause" indicator lamp flashes.
Check whether:
•
the door is properly closed (child safety);
•
the "Start/Pause" button has been pressed;
•
the "Water tap closed" indication lights up. Open the water tap and press the
"Start/Pause" button.
The appliance stops during the programme (varies depending on model)
Check whether:
•
the door has been opened and the "Start/Pause" indicator lamp is flashing. Close
the door and press the "Start/Pause" button again.
•
check if there is too much foam inside, machine enters kill-foam routine. The
machine will run again automatically after a period.
•
the washing machine's safety system has been activated (see "Fault description
table").
Residue from detergent and additives left in the detergent drawer at end of wash.
Check whether:
•
the cover grid of the softener chamber and the separator of the main wash
chamber are correctly installed in the detergent dispenser and all parts are clean
(see “Cleaning and maintenance).
•
sufficient water is entering. The mesh filters of the water supply could be blocked
(see "Care and Maintenance");
•
the position of the separator in the main wash chamber is adapted to the use of
powder or liquid detergent (see "Detergent and Additives").
Machine vibrates during spin cycle.
Check whether:
•
the washing machine is level and standing firmly on all four feet;
•
the transport bolts have been removed. Before using the machine, it is imperative
that the transport bolts are removed.