Heinner HWDM-H10614B, Руководство пользователя

Страница: 33 / 72

www.heinner.com
Final spin results are poor.
The washing machine has an imbalance detection and correction system. If individual heavy
items are loaded (e.g. bathrobes), this system may reduce the spin speed automatically or
even interrupt the spin completely if it detects too great an imbalance even after several spin
starts, in order to protect the washing machine.
•
If the laundry is still too wet at the end of the cycle, remove some articles of laundry
and repeat the spin cycle.
•
Excessive foam formation may prevent spinning. Use the correct amount of
detergent.
•
Check that the spin speed selector has not been set to "O".
If your washing machine has a time display: the programme time initially displayed is
lengthened/shortened by a period of time
This is a normal capacity of the washing machine to adapt to factors that can have an effect
on the wash programme time, e.g.:
•
excess foam formation.
•
load imbalance due to heavy items of laundry.
•
prolonged heating time due to reduced inlet water temperature.
Because of influences like these, the time remaining in the programme run is recalculated,
and updated if necessary. In addition, during the filling phase, the washing machine
determines the load and if necessary, adjusts the initial programme time displayed
accordingly. During such update periods, an animation appears on the time display.
Cold fill fault
Fix the inlet hose to the cold water tap and to the inlet valve on the rear side of the machine
as below picture.
Ensure that: all connections are tightly fixed.
Do not allow children to operate, crawl on, be near or inside your washer.
Note that during the wash cycles, the surface temperature of the porthole door may
increase.
Close supervision of children is necessary when the appliance is used near children.
Inlet valve
Cold fill