Heinner HOH-S13WH, Инструкция по эксплуатации

Страница: 16 / 37

www.heinner.com 2500W, 50/60Hz, 220-240V
15
1. Place the radiator body upside-down on a scratch-free location, make sure it is
stable and will not fall.
2. Back castor: Screw off the wing nuts from the U-shaped bolt provided, attach
the U-shaped bolt to the U-facing flange between last two fins. To attach the castor
mounting plate to the radiator body, you should insert the threaded ends of the U
bolt in the holes on the castor mounting plate.
3. Front Castor: Put the castor on the front cover against screws.
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage of radiator flange.
5. Repeat 2, 3, and 4 on the rear of radiator for mounting of the rear Castors.
Note: the rear castors must be mounted between the end two fins.
INSTRUCTIONS FOR USE
1. Before using the heater, make sure that it is on a flat and stable surface.
Damage may occur if it is placed on an incline or decline.
2. Set all the controls to OFF position and insert the plug into a socket-outlet
with well grounded. Be sure that plug fits firmly.
3. Rotate the thermostat knob clockwise to MAX position and switch the
heater on as follow: switch position I for low heat, switch position II for
medium heat and III for high heat.
4. When your room reaches the desired temperature, now slowly rotate the
thermostat knob counter clockwise until the pilot light goes out. The
thermostat can now be left at this setting. As soon as the room temperature
has dropped below the set temperature, the unit will switch itself on
automatically until the set temperature has been reached again. In this way
the room temperature remains constant with the most economical use of
electricity.
5. If you want to change the room temperature setting, rotate the thermostat
knob clockwise to raise the temperature, or counter clockwise to lower it.
6. This heater includes an overheat protection system that shuts off the heater
when parts of the heater are getting excessively hot.
7. To completely shut the heater off, turn all the controls to OFF, and remove
plug from the socket-outlet.