41
Oven/Grill (if available) Injectors
The oven and grill injectors are held in position by a single screw on the tip of the burner.
For oven burners, open the drawer compartment and locate the assembly screw below the
burner. Remove the screw, move the burner diagonally and the injector will be revealed on
the rear side of the burner box.
For grill burners, the screw is already visible. Remove the screw, pull the grill burner
towards you and the injector will be visible on the rear surface of the oven cavity.
Remove the injectors using a 7mm spanner and replace the injector with the ones from the
psare set. Make sure you use corresponding diameters suitable to the type of gas that is
going to be used, according to the information chart (which is also supplied in the gas
conversion kit).
Adjusting the minimum flame position
First of all, make sure that the appliance is unplugged from the mains electrical supply and
that the gas feed is open.
The minimum flame position is adjusted with a flat screw located on the valve. As shown in
the figures below; for valves with a flame failure safety device, the screw is located on the
side of the valve spindle and for valves without a flame failure safety device, the screw is
located inside the valve spindle. To make adjusting the flame position easier, we
recommend that you remove the control panel (and the micro switch if your model has
one) during the alteration. The bypass screw must be loosened for conversion from LPG to
natural gas. For conversion from natural gas to LPG, the bypass screw must be tightened.
