Heiniger 708-600, Перевод оригинальной инструкции

Страница: 35 / 240

Translation of the original instructions / Cattle and horse clipper
17
Malfunction Cause Rectification
Clipper cuts badly or
not at all.
Red area visible on
the clipper pressure
display on the adjusting
knob.
Clipper blade is blunt Notify customer service.
Clipper blades have not been
correctly ground
Clipper blades are not oiled
Lubricate the clipping blades
every 15 minutes.
Clipper cuts badly or
not at all
Clipping pressure too low. Increase the clipping pressure,
as described in chapter 6.6.
Leaf springs broken. Notify customer service.
The animal‘s hair is wet. Only clip dry hair.
Hairs jammed between top and
bottom blades.
Remove the clipping blades;
clean, lubricate and install
them again; set the clipping
pressure.
Too much play at the clipper head. Notify customer service.
Clipping blades not properly
aligned.
Align the clipping blades cor-
rectly, see Fig. 17.
Motor does not run or
stops immediately.
Clipping pressure too strong.
Red area visible on the clipper
pressure display on the adjusting
knob.
Reduce the clipping pressure,
as described in chapter 6.6.
Have the blades sharpened.
Battery is dead. Charge battery.
Contacts dirty. Switch clipper off and clean the
contacts.
Faulty battery. Replace battery.
Smell of burning from the motor
housing. Motor burned out.
Notify customer service.
Clipperhead blocked. Remove jamming.
Motor does not run or
stops immediately.
Motor and/or electronics defective. Notify customer service.
Motor runs very slowly. Clipping blades were not oiled
sufficiently.
Lubricate the clipping blades.
Clipping pressure too strong. Reduce the clipping pressure,
as described in chapter 6.6.
Battery almost discharged. Charge battery.
Motor and/or electronics defective. Notify customer service.
Motor unit becomes
hot.
Clipping pressure too strong.
Red area visible on the clipper
pressure display on the adjusting
knob.
Reduce the clipping pressure,
as described in chapter 6.6.
Motor faulty. Notify customer service.
Running time of a fully
charged battery is too
short and / or blades
are getting hot.
Clipper blades were not oiled
sufficiently
Oil clipper blades.
Flat, not fully charged or faulty
battery is being used.
Only use intact, fully charged
original batteries.