HEIDENHAIN GAGE-CHEK 2000 Series, Руководство по эксплуатации

Страница: 199 / 236

Settings |
Axes
Parameter Explanation
Terminating resistor Dummy load to avoid reflections
Settings:
ON
or
OFF
Default value: ON
Error monitor Monitoring of signal errors
Settings:
Off : Error monitoring not active
Amplitude
: Error monitoring of the signal amplitude
Frequency : Error monitoring of the signal frequency
Frequency & amplitude : Error monitoring of the signal
amplitude and signal frequency
Default value:
Frequency & amplitude
A warning or error message is displayed if one of the
limit values for error monitoring is exceeded.
The limit values depend on the signal of the connected encoder:
Signal 1 Vpp , setting: Amplitude
Warning with voltage
≤
0.45 V
Error message with voltage
≤
0.18 V or
≥
1.34 V
Signal
1 Vpp
, setting:
Frequency
Error message with frequency
≥
400 kHz
Signal 11 µApp , setting: Amplitude
Warning with current
≤
5.76 µA
Error message with current
≤
2.32 µA or
≥
17.27 µA
Signal
11 µApp
, setting:
Frequency
Error message with frequency
≥
150 kHz
Counting direction Signal detection during axis movement
Settings:
Positive : The direction of traverse corresponds to the
counting direction of the encoder
Negative
: The direction of traverse does not correspond to
the counting direction of the encoder
Default value:
Positive
Settings for encoders with interfaces of the TTL type
Parameter Explanation
Encoder input Assignment of the encoder input to the axis of the product
Settings:
X21
X22
X23
Further information: "Device overview", Page 43
Interface
Automatically detected
TTL
interface type
11
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
199