Heatmiser PRTHW-TS, Руководство по эксплуатации, Страница: 12 / 40

On the PRTHW-TS WiFi RF:
• Press Prog then Setup.
• At the top of the screen press the Up button to select
feature 06.
• Use the up/down buttons in the centre of the screen & set
the large number to 01, this configures the thermostat to
communicate with the RC1-W.
• Press the UP button at the top of the screen to select
feature 07.
• Use the up/down buttons in the centre of the screen to
select the RC1-W receiver address you are
communicating with.(01-32)
• The heating output will be automatically assigned to zone
1 and the hot water will be zone 2.
• Press the DONE button.
To pair the thermostat with the receiver, press & hold the
SCREEN button for 10 seconds:
10