4
595-5657-04
1. Walk through the coverage area noting
where you are when the lights turn on.
Loosen the 3 clamp screws slightly and
turn the sensor head left or right to change
the coverage area.
2. When you have the desired coverage
angle make a pencil mark on the sensor
and post to mark the sensor position.
3. If you need to change the sensitivity, tem-
porarily lift the fixture and sensor to make
the adjustment. It may be necessary to
have a friend hold the fixture while adjust-
ing the sensitivity. Too much sensitivity may
increase false triggering.
4. Set the amount of TIME you want the
light to stay on
after motion is
detected. (1, 5, or
20 minutes).
5. Set the D
ual
B
rite
®
(ACCENT) switch
to the amount of
time after dusk you
want the lights on
at low level (Off,
3, 6 Hrs., Dusk-to-
Dawn).
SECURING BRASS AND
PLASTIC POST LAMPS
1. Turn the post lamp to the desired loca-
tion. Using a #31 drill and the fixture as a
template slightly mark the location of one
of the fixture mounting holes. DO NOT drill
through the sensor plastic.
2. Lift the fixture off the sensor and keep the
wires away from where you need to drill.
Now finish drilling the first hole.
3. Set the fixture in position and install a
screw (provided) to hold the fixture.
4. Mark the remaining holes as above.
5. Remove the one screw and lift the fixture
and drill the remaining holes as above.
6. Set the fixture in position and install all
the screws (3 provided). Be careful to not
over tighten the screws and strip out the
plastic.
SYMPTOM
Light stays on
continuously.
Light flashes on
and off.
POSSIBLE CAUSE
1. The sensor is pointed at nearby
objects that cause heat to trigger
the sensor.
(Aim the sensor away
from nearby objects)
.
2. Light control is in Manual Mode.
(Switch to Auto.)
3. Light control is in D
ual
B
rite
®
mode.
4. Sensitivity is set too high.
(Reduce
sensitivity.)
1. Heat being reflected from other
objects may be affecting the sensor.
(Re-aim sensor)
.
2. Light control is in the Test mode and
warming up.
(Flashing is normal
under these conditions)
.
POSSIBLE CAUSE
1. Light switch is turned off.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker is turned
off.
4. Daylight turnoff is in effect
(Recheck
after dark)
.
5. Incorrect circuit wiring, if this is a new
installation.
6. Re-aim the sensor to cover desired
area.
1. Light control may be installed in a
relatively dark location.
2. Light control is in Test.
(Set control
switch to an ON-TIME position)
.
1. Light control may be sensing small
animals or automobile traffic
(Re-aim
sensor)
.
2. Sensitivity is set too high.
(Reduce
sensitivity)
.
SYMPTOM
Light will not
come on.
Light comes
on in daylight.
Light comes
on for no ap-
parent reason.
TROUBLESHOOTING GUIDE
WARNING: Turn power off at circuit
breaker or fuse.
ON-TIME
MINUTES
ACCENT
DUSK TO DAWN
6 HOUR
3 HOUR
OFF
20
5
1
TEST
6 Put the sensor and fixture back in place.
Align the pencil marks made above.
Tighten the three screws to secure the
sensor.
