25
Glass Specifications: GRAND-50-D 30” x 48” TEMPERED
Heat-N-Glo fireplaces manufactured with tempered glass
may be installed in hazardous locations such as bathtub
enclosures as defined by the CPSC. The tempered glass
has been tested and certified to the requirements of ANSI
Z97.1-1984 and CPSC 16 CFR 1202. (Safety Glazing Certi-
fication Council SGCC # 1595 and 1597. Architectural Test-
ing, Inc. Reports 02-31919.01 and 02-31917.01.)
This statement is in compliance with CPSC 16 CFR Sec-
tion 1201.5 “Certification and labeling requirements” which
refers to 15 USC 2063 stating “…Such certificate shall ac-
company the product or shall otherwise be furnished to any
distributor or retailer to whom the product is delivered.”
Some local building codes require the use of tempered glass
with permanent marking in such locations. Glass meeting
this requirement is available from the factory. Please con-
tact your dealer or distributor to order.
• Glass can now be reinstalled, followed by glass clips
and wing nuts (see Figure 30). Wing nuts should be hand
tightened only. Finish the installation by installing deco-
rative door.
Figure 30. Glass Assembly
GLASS CLIPS
Step 11. Before Lighting the Fireplace
BEFORE
lighting the fireplace, be sure to do the following:
• Remove
all paperwork from underneath the fireplace.
• Review
all cautions, and Safety and Warnings section
at the beginning of this Installers Guide.
• Double-check
the unit for possible gas leaks.
• Double-check
the unit for possible obstructions that
could be blocking the vent terminations.
• Double-check
for faulty components: Any component
that is found to be faulty
MUST BE
replaced with an ap-
proved component. Tampering with the fireplace compo-
nents is
DANGEROUS
and voids all warranties.
A small amount of air will be in the gas supply lines. When
first lighting the fireplace, it will take a few minutes for the
lines to purge themselves of this air. Once the purging is
complete, the fireplace will light and will operate normally.
Subsequent lightings of the fireplace will not require this
purging of air from the gas supply lines,
unless
the gas
valve has been turned to the OFF position
, in which
case the air could have to be purged again.
NOTE:
The fireplace should be run 3 to 4 hours on the initial
start-up. Turn it off and let it cool completely. Remove and
clean the glass. Replace the glass and run the fireplace for
an additional 8 hours. This will help to cure the chemicals
used in the paint and logs.