48
Heat & Glo • LUX36, LUX42 Installation Manual
• 2287-980 Rev. L
• 2287-980 Rev. L • 4/16
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath
the
fi
rebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before
fi
nishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative front of the unit, de-
pending on the
fi
replace model. Splatter guards
must be removed before appliance is
fi
red.
WARNING! Risk of Fire!
Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the
fi
rebox or underneath in the control cavity.
D. Glass Refractory Installation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation.
CAUTION! Glass is fragile.
Handle with care.
1. Remove rear and side glass retainer brackets as shown
in Figure 11.10. Retain fasteners for use in Steps 3-5.
2. Locate notch on rear corners of log mount plate for rear
glass assembly.
3. Place rear glass assembly into notches in appliance and
tilt upright into position. While holding glass in position,
reattach glass retainer with fasteners saved in Step1.
Do not overtighten.
4. Slide left glass assembly into left side of appliance.
Attach glass retainer with fasteners saved in Step 1. Do
not overtighten. See Figure 10.11.
5. Slide right glass assembly into right side of appliance.
Attach glass retainer with fasteners saved in Step1. Do
not overtighten.
RETAINER BRACKETS
NOTCHES FOR REAR GLASS PANEL
Figure 11.10 Remove Retainer Brackets
Figure 11.11 Side Panel Installation
Figure 11.12 Glass Refractory Installed
LEFT
REAR
RIGHT
A
B
A
B
LUX36
26-5/8 IN.
23-5/8 IN.
LUX42
31-5/8 IN.
29-5/8 IN.
Figure 11.9 Refractory Glass Panels