17
The left and right displays can show the approxi-
mate total number of calories you have burned and
total number of miles the walking belt has moved.
To see the total number of miles and calories,
press the Total button. The total number of calories
will be shown in hundreds of calories. For example,
if the display shows a 3, you have burned approxi-
mately 300 calories. To view the number of calo-
ries and miles for the current exercise session,
press the Trip button.
You can change the volume level by pressing the
Volume increase and decrease buttons. To mute
the volume, press the Volume decrease button
until only one bar appears in the display.
As you exercise, the workout intensity meter will in-
dicate the approximate intensity level of your exer-
cise. For example, if five of the indicators in the
meter are lit, you are exercising at a medium inten-
sity level.
To reset the displays, press the Stop button, re-
move the key, and then reinsert the key.
6. Measure your heart rate if desired.
Before using
the handgrip
pulse sensor,
remove the
sheets of clear
plastic from the
metal contacts.
In addition,
make sure that
your hands are clean.
To measure your heart rate,
stand on the foot
rails
and hold the metal contacts—
avoid moving
your hands.
When your pulse is detected, one or
two dashes will appear and then your heart rate
will be shown. In addition, each time your pulse is
detected, a peak will appear in the line next to your
heart rate.
For the most accurate heart rate
reading, continue to hold the contacts for
about 15 seconds.
7. Turn on the fan if desired.
The fan features high, low, and auto speed set-
tings. Press the Fan button repeatedly to select a
fan speed or to turn off the fan. When the auto
mode is selected, the speed of the fan will auto-
matically increase and decrease as the speed of
the walking belt increases and decreases. Note: If
the fan is on when the walking belt is stopped, the
fan will turn off automatically after a few minutes.
The auto mode can only be selected while the
walking belt is moving.
8. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest set-
ting when you fold the treadmill to the storage
position, or you may damage the treadmill.
Next, remove the key from the console and put it in
a secure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord.
IMPORTANT: If you do
not do this, the treadmillʼs electrical compo-
nents may wear prematurely.
Contacts
