9
HOW TO ADJUST THE POSITION OF THE SEAT
For effective exercise, the seat should be in the proper
position. As you pedal, there should be a slight bend
in your knees when the pedals are in the farthest
position. To
adjust the seat,
pull the seat
knob and slide
the seat car-
riage to the
desired posi-
tion. Release
the seat knob
and
slide the
seat carriage
back and forth
slightly until it
locks into position.
HOW TO ADJUST THE PEDAL STRAPS
To adjust the
pedal straps, first
pull the ends of
the straps off the
tabs on the ped-
als. Adjust the
straps to the
desired positions,
and then press
the straps back
onto the tabs.
Seat Knob
Seat
Carriage
Strap
Tab
ADJUSTMENT AND OPERATION
2. Plug the short jumper wire (A) into the indicated jack on
the Console (9). Connect the other end of the short
jumper wire to the wire on the receiver (B). Note: Any
other wires included with the chest pulse sensor can be
discarded.
Next, peel the paper off the adhesive pad on the back
of the receiver (B). Orient the receiver as shown, and
press it onto the Console (9) in the indicated location.
Refer to step 1 above. Reattach the front of the
Console (9) with the short and long screws.
Make sure
that no wires are pinched.
B
9
Jack
A
Cylinder
2
INSTALLING THE RECEIVER FOR THE OPTIONAL
CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (refer to
page 18), follow the steps below to install the receiver and
the short jumper wire included with the chest pulse sensor.
1. Remove the two short screws and the two long screws
from the back of the Console (9). Lift off the front of the
Console.
9
Lift
Here
1
Short
Screws
Long
Screws
