head rush technologies QuickFlight QF150-12A, Руководство оператора

Страница: 47 / 54

ALWAYS USE A NEW SHACKLE PIN PROVIDED WITH THE WEBBING REPLACE-
MENT KIT. NEW SHACKLE PINS COME WITH THREAD LOCKING COMPOUND
THAT CAN ONLY BE USED ONCE.
6. Install the new Upper Webbing and new Shackle Pin, ensuring the shackle
loop is fitted to the drum lead and shackle pin to the end of the webbing.
Ensure that the new webbing assembly is correct for the device model,
mounting configuration, and RipCord configuration.
7. Tighten the shackle pin until fully seated.
8. Remove the holding pin and allow the Upper Webbing lines to slowly
retract without twisting until the drum leads and sewn webbing ends are
inside the device.
TWISTED WEBBING WITHIN THE DEVICE MAY CAUSE THE NOZZLE ASSEMBLY TO
DISCONNECT FROM THE DEVICE CASING, LEADING TO SUDDEN AND EXTREME
WEBBING WEAR, WEBBING SEPARATION, SERIOUS INJURY, OR DEATH.
9. Replace the nozzle assembly.
10. Allow the webbing lines to slowly retract into the device without twisting
while maintaining constant tension. Ensure the retraction force is smooth
and adequate resistance is felt.
11. Once the webbing lines are fully retracted, pull hard on both lines at once,
extracting a short length (~1m) of webbing. Repeat up to three times to
ensure that the dual webbings are equally stretched and tightly wound
onto the drum.
12. Ensure that one Upper Webbing is fully retracted and that the other Upper
Webbing is no more than 0.3m (1 ft) extracted from the nozzle.
13. Connect the colored end of the Upper Webbing to the Webbing Connec-
tion Ring that was previously disconnected, following the manufacturer’s
instructions to ensure that the Connection Ring is properly closed. Ensure
that there are no twists between the RipCord Webbing and the Upper
Webbings.
14. If necessary, reinstall the QuickFlight to its properly mounted position.
47
headrushtech.com | +1-720-565-6885