HDBaseT SSH70, Руководство пользователя

Страница: 13 / 16

V2.1 13
Automatic CEC Display Control
The following commands set the operating mode for automatic CEC control of the display
“power on” and “power off”. The CEC “power off” command can be sent after a specified time
delay. The CEC “power on” command will be sent immediately when a new input HDMI signal
is detected. To use this feature, the CEC Auto ONOFF must be enabled (ON) (default: OFF)
Commands Details
SET TX AUTO-ONOFF-CONFIG ON

Enable automatic CEC power on and power off control.
SET TX AUTO-ONOFF-CONFIG OFF

Disable automatic CEC power on and power off control.
(default)
SET TX AUTO-OFF-TIMER x

(default: 30 minutes)
x = 1 to 240 minutes.
Values above 240 are ignored (current setting maintained).
Set the time in minutes before sending the CEC power off
message, if enabled.
TX POC Commands
These commands set the operation of the Power-Over-Cable (POC) mode of the Transmitter.
Commands Details
SET TX HDBTPOC ON

The supplied DC voltage is always present on the HDBaseT port.
SET TX HDBTPOC OFF

No power is applied to the HDBaseT port.
SET TX HDBTPOC AUTO

When the Tx is powered from 24V, then the 24V is always sent to
the HDBaseT port. (default setting)
When the Tx is powered from 48V, iPoC mode will be used.
SET TX HDBTPOC iPOC

The iPoC mode only outputs a voltage to the HDBaseT port only if
an iPoC (SSH70) Receiver is detected. It will NOT provide power to
any non-iPoC receivers.
GET TX HDBTPOC

Get the TX POC status.
RX POC Commands
These commands set the operation of the Power-Over-Cable (POC) mode of the Receiver.
Commands Details
SET RX HDBTPOC ON

The supplied DC voltage is always present on the HDBaseT port
SET RX HDBTPOC OFF

No power is applied to the HDBaseT port.
SET RX HDBTPOC AUTO

When the Rx is powered from 24V, then the 24V is always sent to
the HDBaseT port. (default setting)
When the Rx is powered from 48V, iPOC mode will be used.
SET RX HDBTPOC iPOC

The iPoC mode only outputs a voltage to the HDBaseT port only if
an iPoC (SSH70) Transmitter is detected. It will NOT provide power
to any non-iPoC transmitters.
GET RX HDBTPOC

Get the RX POC status.
Volume Mute
SET TX CEC-MUTE

Mute/Unmute sound volume (Toggle)
Display Connection Status
GET TX READ-DISPLAY
 Get the current Connected/Disconnected info
Display Power Status
GET TX DISPLAY-POWER
 Get the current display device power on/off info