
H B X E C O - 0 5 5 0 G e o t h e r m a l C o n t r o l
V e r s i o n 2 . 0 0
Page 4
Geothermal Mode
Programming for this mode can be found on pages 7 through 15. This mode is used
when running heat pumps/chillers or geothermal related installations. The control
will run up to 3 stages of heat pumps, a reversing valve for heating and cooling
applications, as well as single or dual tanks. This mode also allows for a built-in backup
feature.
CONTROL MODE
The programming instructions for the ECO-0550 are currently selectable in the mode listed below. When the
control is first plugged in you are asked to select which control mode you would like your ECO-0550 to operate
in. To select your control mode simply use the ▲ or ▼ buttons to select the correct mode then wait five
seconds to accept your selection.
NAVIGATING THE ECO-0550
All programming steps within the ECO-0550
are achieved by using the three buttons (and
combination thereof) located below the screen.
The ▼ button is used to scroll down in menu screens
and decrease a value within specific options.
The ▲ button is used to scroll up in menu screens
and increase a value in specific options.
The
ENTER
button is used to access the setpoint
menu and select a setting.
ECO-0550
Central Processing Unit
Relays:
240VAC 5A Max
Input:
120VAC 15A Max
ENTER
ECO
Input
Signals (4)
Heat Pump
Outdoor
Sensor
120
VAC
Relay
Outputs (2)
Reversing
Valve
Tank
Sensor (2)
CHOOSE CONTROL TYPE
1) GEOTHERMAL
1.10