HBS CPW 0604, Руководство по эксплуатации, Страница: 19 / 180

CPW 0604 BA CPW 0604 Issue 10.09.13 (From Software-Release 0.0.1.31) 19
3 Starting-up
In this chapter you learn what to observe during setting-up and starting-up of the CNC
Production Welder.
3.1 Requirements of Workplace
Vapors and airborne particles may occur during stud welding
operations. Especially with surface treated materials, toxic
vapors may be produced.
‹
Ensure that a fume extraction is available and that the room is adequately
ventilated according to accident prevention regulations.
‹
If possible, do not weld in rooms which are lower than 3 meters.
‹
Special regulations apply for confined rooms, according to accident prevention
regulations of the official bodies (see appendix).
‹
Weld only in adequate distance from combustible articles or liquids.
‹
Before you start welding, remove any combustible articles or liquids in vicinity of
the workplace.
‹
Make sure that a fire extinguisher is within reach.
‹
Never weld in rooms exposed to risk of explosion.
‹
Do not set-up the product in the vicinity of any apparatus or equipment which is
sensitive to welding spatters.
‹
Do not set-up the product in the vicinity of any apparatus or equipment which is
sensitive to magnetic fields.
‹
Set-up the CNC Production Welder:
– on a stable, clean, and level surface
– so that no-one is influenced or injured by welding spatters
– so that all cables and primary lines are protected from being damaged
– so that nobody will trip or fall over the cables or connection lines.
‹
Ensure that air is able to circulate freely through the housing.
If heat is built-up inside the housing caused by bad air circulati-
on, the stud welding unit will be seriously damaged.
3 Starting-up
3.1 Requirements of Workplace