HB-THERM M8146-EN, Руководство по сборке

Страница: 14 / 16

Assembly Instructions M8146-EN
M8146-EN 2019-07
14/16
Complete linear stepper motor
(O/ID T27595, T28433)
1. Carry out preparation (

page 3).
on the multiphase motor, the switching module (M 5,6)
2. Proceed as follows to disassemble the multiphase
motor (M 5,6):
Fig. 26: Remove switching unit buffer (19)
CAUTION!
Risk of burns!
During operation, the multiphase motor (M 5,6)
becomes hot. Danger of burns, if touched.
Therefore:
– Wear thermal gloves when touching or let the
multiphase motor cool down.

In order to remove the switching buffer unit (19), disassemble
2x pipe couplings (label 1) and remove 2x screws (label 2).

Remove the switching buffer unit (19) on the side.

To disassemble the protection cover of the accumulator (16),
remove 2x screws (label 3).
Fig. 27: Remove the multiphase motor
M 5,6
NOTICE!
Observe following when disassembling the
multiphase motor:
- Positioning of the multiphase motors

Preparation page 3.
- Alignment of the groove of the coupling, to allow the
piston rod to extend

Fig. 29.

Withdraw the cable connector of the multiphase motor (M 5.6).

Loosen the 4 fixing screws (label 4) (approx. 8-10 mm).

Slightly pull out downwards the multiphase motor (M 5,6) and
move out of coupling.
F
Fig. 28: Mount the multiphase motor M 5,6
3. Proceed as follows to mount the multiphase motor (M 5,6):
NOTICE!
Observe following when mounting the multiphase
motor:
- Loosen the 4 fixing screws enough (approx.
8-10 mm) to enable an easier installation.
- Alignment of the groove of the coupling, to allow
the piston rod to retract (label 7

Fig. 29.).

Engage the multiphase motor, turn into final position and fix
with the 4 screws.
1
3 2
4