34
^
hazet.com
•
]
Electrical energy may cause serious injuries!
Always wear personal protective equipment!
3
Design and function
Adjusting the wheel guard
The guard is pre-adjusted to the diameter of the gear case
hub at the factory. lf, after a period of time, the guard
becomes loose, tighten the adjusting screw (1) with the
latch in the closed position and the guard installed on the
tool.
Spindle lock
The spindle lock button (1) is provided to prevent the
spindle from rotating when installing or removing wheels.
Operate the spindle lock only when the tool is turned off
and the wheel has come to a complete stop .
To engage the lock, press the spindle lock button (1) and
rotate the spindle until you are unable to rotate the spindle
further.
Caution!
Guards must be used with grinding wheels and cut-off wheels. The grinder is provided with
a grinding guard intended for use with grinding wheels and a cutting guard intended for
use with cutting wheels.
Make sure the wheel guard is locked properly and in protection angle position, otherwise a
broken blade might cause serious injury.
To prevent accidental operation, turn off the tool and remove the battery pack before per-
forming the following operations. Failure to do this could result in serious personal injury.
lf the guard cannot be tightened by the guard latch, do not use the tool and take the tool
and guard to a service centre to repair or replace the guard.
