Hayward CAT 4000, Руководство пользователя

Страница: 27 / 36

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
26
Store sensors in the soaking caps provided, making sure that each container is filled with the origi-
nal storage solution or clean water. If the storage containers have been misplaced, store sensors
individually in small glass or plastic containers with clean water covering sensor tips.
Controller Storage
The controller unit is subject to damage by electro-static discharge (ESD) when the sensor cables
are disconnected. Always reinstall the BNC protective covers prior to storing or transporting the CAT
4000 controller unit.
Winterization
The sensors should be prepared for storage as outlined above and protected from freezing tem-
peratures. Although the CAT 4000 controller is designed to withstand a broad temperature range,
winter storage in a secure location may be desirable.
The flow cell and poly tubing must be drained prior to exposure to freezing temperatures. Either
purge all water using compressed air or thoroughly drain through the valve ports and tubing con-
nections.
Network Communications
Cell and Satellite
All CAT controllers set up on Cell and Satellite networks come already activated for wireless com-
munication. Once the unit has been installed and registered on www.poolcomm.com, the devices
will begin to communicate. Local reception and antenna positioning can affect communication ca-
pability, if the unit does not communicate please call 301-838-4001 and ask for technical support.
WIFI
WIFI Controllers communicate via local WIFI networks. Before these units can begin to communi-
cate, they must be configured to connect to the local WIFI network. Please consult the WIFI Con-
nectivity Checklist also included for technical information and see WIFI Connectivity Setup included.
Test w/ a CAT 4000
The best way to check for coverage at a facility is to test with an actual CAT 4000. The Transmit
data button has been provided specifically for this purpose. Place the CAT 4000 unit where you
expect to install it and press the transmit data button. Within 2 minutes a service request alarm will
be generated. This alarm will show up at the POOLCOMM web site, and can also be directed to
your cell phone or portable 2-way device. Make sure your email address has been entered under
Notifications and that address box is checked on the unit management page.