The ‘Check Salt’ & ‘Inspect Cell’ LED’s will flash when the cell reports the salt
level is between 2400-2700ppm. In this condition chlorine is still being produced.
The ‘Check Salt’ & ‘Inspect Cell’ LED’s will be ON when the cell reports the salt
level is 2300ppm or less. In this condition, chlorine production is interrupted.
Test the salt level in the pool using an
independent testing method. If the salt level is
between 2700-3400ppm, go to step 1B. If salt
level is below the recommended range, add
enough salt to achieve a salt level of 3200ppm.
(Refer to Salt Chart, Page 29).
Inspect the turbo cell.
If cell looks like 4A, go to step C. If cell looks
like 4B, clean cell. (Refer to Pages 17 thru 19).
After the cell is clean go to step 1C to reset.
Page 4
NOTE:
‘Check Salt’ & ‘Inspect Cell’ LED’s may also be ON if the
control is set for the wrong Cell type or the cell is unplugged.
Step 1A
Step 1B
1. Check Salt & Inspect Cell
LED flashing or ON
