01/21 1210 Series Bottle Fillers
Page 2 of 17
REQUIRED TOOLS (OR EQUIVALENT):
□ Adjustable Wrench
□ 1/4” Bit-holding screwdriver (7-3/4” max length)
□ 1/4” Bit-holding screwdriver (4” max length, required for installs at Child ADA height only)
□ #2 Phillips bit and a Flat-blade bit
□ T20 Torx bit (supplied)
□ 5/16” Nut driver bit (not necessary but will make some steps easier)
□ Trimming tool for ABS pipe (necessary for some retrofits)
□ Small bubble level
□ Tape measure and tools for properly marking and measuring wall
□ Clean cloth or paper towels
□ Tubing cutter for polyethylene tubing
□ Small diagonal cutting pliers
□ Permanent Marker
REQUIRED PARTS (NOT SUPPLIED):
□ P-trap (1-1/4” such as Keeney 200W recommended) with appropriate seal for 1-1/4” OD tailpiece
□ Suitable trap adapter (if not already installed – see installation drawing for details)
□ Suitable angle stop valve with 3/8” compression outlet (if not already installed – see installation
drawing for details)
□ 1/4” fasteners suitable for fastening the unit into structural material in wall.
□ Plastic cup (for bleeding air out of system following install)
LOCATION OF UNIT:
The Model 1210XX Series are suitable for indoor use only. These
units are unsuitable for corrosive environments (such as enclosed chlorinated pool areas) or
very dusty areas. The ambient air temperature must be maintained between 40°F and 94°F at
all times. Installation into a location not meeting these limitations will void the warranty.
SUPPLY LINE:
The minimum
recommended size is 1/2“IPS with 30-90 psig (2-6 ATM)
flowing pressure. Where sediment or mineral content is a problem, an upstream water pre-
filter is recommended.
PLUMBING CONNECTIONS:
Inlet is 3/8” OD polyethylene tubing. A suitable plastic ferrule
and metal insert are provided to allow direct connection to a 3/8” compression water stop
valve. Tailpiece is 1-
1/4” OD ABS.
ELECTRICAL CONNECTION:
120VAC/60HZ GFCI-Protected electrical receptacle, min 15A
service. Us
e standard size 4.5” X 2.75” wall plate. Dedicated circuit recommended.
INSTALLATION PROCEDURE
GENERAL NOTES:
•
For all plastic push-in type fitting connections, only connect NSF-61 soft-copper or
plastic tubing. These instructions must be followed to ensure a watertight connection:
a. If tubing needs to be shortened, cut tubing square and clean.
b. Mark from end of tube the depth of insertion (See table below).
c. Push tube into the fitting until it bottoms out.
d. To remove, depress collet and pull tubing out.
Tube OD Size
OD Tolerance
Insertion Depth
1/4”
±.004
”
11/16”
3/8”
±.004
”
3/4”
