Hawkeye Mfg H8932, Руководство по установке

Страница: 1 / 11

-1-
Installation Instructions
H8932, H8936
Network Display
OPERATION
The H8932/H8936 Network Display provides local indication of power system
parameters from Veris devices. To report critical alarm data the H8932/H8936
is equipped with a digital alarm input and local alarm annunciation.
All system variables and alarms can be passed to the network operations
center by means of Modbus RTU protocol. In the event that the network
operations center is not yet established, the data can be uploaded to a Palm
Pilot through the IR communications port located on the front of the display.
Comprehensive Power Monitoring Display

Monitor critical parameters with one networked display

Supports a variety of sensors
• H8035/6 Enercept Power Meters
• H704-42 Branch Current Monitors
• H663 Branch Current Monitors
• H8238 Multi Circuit Monitors
• H8160 Series Energy Meter

Membrane switch buttons provide convenient setup and viewing of
data from all devices on the power monitoring network

Pass through communications to other Modbus devices
Presents System Data Visually and to a Network

Large backlit LCD...easy to read

Palm OS Infrared interface...instantly upload data from all
Veris devices to a palm pilot, or use a Modbus network

Modbus protocol communications, one digital input standard

Upstream communications selectable RS485, RS232, or infrared

Multi color LED...provides quick system status
• This product is not intended for life or safety applications.
This product is not intended for installation in hazardous or classified
locations.
• Potential electrocution hazard exists. Installing sensors in an
energized motor control center or on any energized conductor can be
hazardous.
• Read instructions thoroughly prior to install
Severe injury or death can result from electrical shock during contact with
high voltage conductors or related equipment. Disconnect and lock-out
all power sources during installation and service. Applications shown are
suggested means of installing sensors, but it is the responsibility of the
installer to ensure that the installation is in compliance with all national
and local codes. Installation should be attempted only by individuals
familiar with codes, standards, and proper safety procedures for high-
voltage installations.
Z102662-0C
PORTLAND, OREGON USA
(503) 598-4564 FAX (503) 598-4664
1-800-354-8556
VERIS INDUSTRIES
http://www.veris.com email:sales@veris.com ®