Haussmann X-PERT HETS-001, Руководство оператора, Страница: 27 / 36

63
REPLACING THE CARBON BRUSHES
(FIG. PP, QQ)
Always disconnect the plug from the power source
before inspecting the brushes.
The carbon brushes included with the unit will last
approximately 50 hours of running time, or 10,000 ON/
OFF cycles. Replace both carbon brushes when either
has less than 1/4’’ length of carbon remaining, or if the
spring or wire is damaged or burned.
1. Remove the blade guard, blade, rip fence, mitre
gauge and stand assembly from the table saw.
2. Place cardboard or an old blanket on the floor to
protect the saw table surface.
3. Place the saw upside down on the protective
material.
4. Tilt the blade elevation/tilting handwheel (1) to the
45° position.
Fig. PP
5. Remove the black plastic cap (2) from the side of the
motor (3).
6. Carefully remove the spring-loaded cap, and then
pull out the brush and replace.
7. Replace the other side.
8. The ears on the metal end of the assembly go
in the same hole the carbon part fits into. Do not
overtighten the plastic cap.
9. Carefully set the saw in a upright position on a clean
level surface.
10.Replace the blade guard, blade, rip fence, mitre
gauge and stand assembly to the table saw.
NOTE:
To reinstall the same brushes, first make sure
the brushes go back in the way they came out. This will
avoid a break-in period that reduces motor performance
and increases wear.
Fig. QQ
LUBRICATION
All motor bearings are permanently lubricated at the
factory and require no additional lubrication.
On all mechanical parts of your table saw where a pivot
or threaded rod are present, lubricate using graphite or
silicone. These dry lubricants will not hold sawdust as
would oil or grease.
2
3
WARNING

!
1