Haussmann X-PERT HETS-001, Руководство оператора, Страница: 13 / 36

49
contacting the floor and are at a similar angle to the
floor.
NOTE:
Make sure the table saw is locked securely in
position. Adjust the levelling pad to make sure the table
saw is totally stable.
FOLDING THE STAND (FIG. F, G)
1. Raise the cover (1) first and pull the locking handle (2)
out. (Fig. F)
2. Push downward on the stand slowly, as illustrated.
3. Release the locking handle (2) to lock the stand into
position. Lower the cover (1). (Fig. F)
4. Rotate the stand hook (3) onto the stop screw (4) and
place bands to secure the stand legs into position.
(Fig. F)
5. Lock the cam locking lever (7) by pushing it in
downward. (Fig. G)
NOTE:
For convenient storage, there are two stand
up supports (6) in the right side of the table saw for
supporting the table saw when not in use. (Fig. G)
Fig. F
Fig. G
MOUNTING THE SAW TO A WORK SURFACE IF THE
STAND IS NOT USED (FIG. E)
Failure to provide a sawdust fall-through hole when
the saw is mounted to a work surface (instead of the
stand) will cause sawdust to build up in the motor
area. This can result in fire or cause damage to the
motor.
1. If not using the stand, the saw must be properly secured
to a sturdy workbench through the four mounting holes
that are located at the base of the saw.
2. The surface of the table where the saw is to be
mounted must have a hole that is large enough to
facilitate sawdust fall-through and removal.
3. Square the saw on the mounting surface, and mark the
location of the four 3/8’’ mounting holes (1).
4. Drill 3/8’’ hole in the mounting surface.
5. Mark an 11 x 11’’ square (2), centered between the
four mounting holes (1).
6. Cut out and remove the square.
7. This opening will allow sawdust to fall through the
saw base.
8. Place the saw on the work surface, and align the
mounting holes of the saw with the holes that have
been drilled through the surface.
9. Fasten the saw to the work surface.
Do not operate this saw on the floor. Doing so is
very dangerous, and may cause serious injury.
Fig. E
SETTING UP THE STAND (FIG. A, B, F)
1. Remove the band (23) and then release the stand
lock hook (17) by sliding it away from the stop screw
(20). (Fig. A)
2. Raise the cover (1) first and pull the locking handle (2)
out. (Fig. F)
3. Step on the pedal (5-Fig. F) and pull the stand
upward until it is fully unfolded.
4. Release the locking handle (2) to lock the stand into
position. Lower the cover (1). (Fig. F)
NOTE: Make sure the stand is locked securely.
5. Place the stand on a level surface and adjust the
left rear leveling pad (16-Fig. B) so that all legs are
WARNING

!
WARNING

!
SQUARE
CUTOUT
1
2
1
2
5
3
4
6
7