Haussmann X-PERT HETS-001, Руководство оператора, Страница: 15 / 36

51
FIG. J
Fig. K
REMOVING THE BLADE (FIG. K)
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
1. Remove the table insert and raise the blade to the
maximum height by turning the blade elevation
handwheel clockwise.
2. Lift the blade guard and position it toward the rear of
the table.
3. Adjust the blade to the 90° vertical position by
unlocking the blade tilting lock knob and turning the
bevel tilting handwheel counterclockwise, and then
lock into position.
4. Pull the motor locking lever (1) toward the front of
the tool while spinning the blade until the latch locks
into place and the blade will no longer turn.
5. Place the blade wrench (3) on the arbour nut (4).
6. Loosen and remove the arbour nut and the flange by
pulling the wrench towards the front of the machine.
7. Then remove the blade (6). Clean but do not remove
the inner blade flange (5) before reassembling the
blade.
7
2
8
9
3
4
5
6
1
WARNING

!
BLADE GUARD ASSEMBLY (FIG. L, M)
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
●
When installing the blade guard, cover the blade
teeth with a piece of folded cardboard to protect
yourself from possible injury.
●
Never operate this machine without the safety
guard in place for all through sawing operations.
Installing the blade guard assembly (Fig. L)
1. Remove the table insert.
2. With the blade elevation handwheel (1), raise the
blade arbour to the maximum height.
3. Loosen the blade lock handle (2) do not pull on
handle just turn and move the handwheel (1) to 45°
on the bevel scale.
4. Tighten the bevel lock handle.
5. Locate the splitter assembly mounting bracket (3) at
the rear of the blade.
6. Cover the blade teeth with a folded cardboard or
position the plastic blade guard over the blade to
protect your hands.
7. Place the two kickback pawls (4) toward the rear of
the table, and align the splitter mounting holes to the
holes in the bracket.
8. Place the spring washer first and then flat washer
onto the blade guard lock knob and thread the
lock knob (5) into the mounting hole, then tighten
securely.
9. Return the blade to 90
º
and replace the table insert.
NOTE: Be careful of the saw blade.
NOTE: Make sure the “anti-kick back pawls do not
get caught between the insert and the guard, but
rest on top of the insert.
Fig. L
WARNING

!
2
3
5
1
4