Haulotte HT23RTJ O, Книга по эксплуатации

Страница: 500 / 534

500 4001055250 E 10.21 USA / GB
HT23RTJ O - HT23RTJ O SW - HT67RTJ O - HT23RTJ PRO - HT23RTJ PRO SW - HT67RTJ PRO
E
- Trouble shooting and diagram
F07.39
Fuel level sensor
SL300
D 1 b0
Open circuit on fuel level sensor (only for analog fuel level sensor type) :
Check fuel level sensor SL300
--> SL300 > 500 ohms & CONFIG[FuelLevelSensorType] = Analog
D 2 b1
Short circuit to ground on fuel level sensor (only for analog fuel level sensor type) :
Check fuel level sensor SL300
--> SL300 = 0 ohms & CONFIG[FuelLevelSensorType] = Analog
F07.40
Twilight sensor
SN900
D
1
Twilight sensor is out of range (Short circuit)
--> SN900>4.8V
2
Twilight sensor is out of range (Open circuit)
--> SN900<0.2V
Failures N Dec Bit Description
Supplies
F08.04
Calc. Input Supply
U104 / U106
D
Detected ECU voltage difference --> Difference between U106 (SPU) and U104
(basket B2)
• Check U100, U104 and U106 supply voltage
• Check fuses
• Check supply voltage coherence between all ECU (more than 2000 V far during the
first 4 seconds after start)
F08.05
Calc. Input Supply
U106 5V regul
D 1 b0
Failure on regulated 5 V output of U104 ECU (basket slave node ) supplying the
joysticks. --> 5 V output is measured out the range [4.5;5.5]V and 5 V output not
failing
• Check fuses
• Check the harness (check short circuit to power supply, to ground supply, open
circuit…)
D 2 b1
Failure on regulated 5 V output of U104 ECU (basket slave node ) supplying the
joysticks. --> Detected failure on 5 V output
• Switch OFF/ON the machine, check the failure has gone (probable cause: internal
failure of the ECU)
F08.08
Unplugged
connector
Connectors / Fuses
D
1 b0
Supplies’ input detected as unplugged on connectors : Check the CN1.B connectors
for U106 ECU :
--> 12VD1<5.00V & 12VF1<5.00V
2 b1
Supplies’ input detected as unplugged on connectors : Check the CN2.A connectors
for U106 ECU :
--> 12VD2<5.00V & 12VF2<5.00V
4 b2
Supplies’ input detected as unplugged on connectors : Check the CN2.B connectors
for U106 ECU :
--> 12VD3<5.00V & 12VF3<5.00V
8 b3
Supplies’ input detected as unplugged on connectors : Check the CN3.A connectors
for U106 ECU :
--> 12VD4<5.00V & 12VF4<5.00V
16 b4
Supplies’ input detected as unplugged on connectors : Check the CN3.B connectors
for U106 ECU :
--> 12VD5<5.00V
Failures N Dec Bit Description
Sensors