Haulotte HT23RTJ O, Книга по эксплуатации

Страница: 166 / 534

166 4001055250 E 10.21 USA / GB
Chassis and turret
Dismantling / Reassembling wheels reducer
MS0026
9. Using appropriale tool install 2 Set Screws ( 1G ) into Bearing Nut ( 1F ) threaded holes. Make sure
Set Screw is driven into the spindle thread. Tighten the set screws to damage the thread and stake
the edge of Ihe nut around the Set Screws ( 1G ) so the nut will not loosen.
10. Insert input Shaft ( 9 ) into mesh with Coupling ( 7 ) intemal splines.
11. Place Thrust Washer ( 4H ) into counterbore of Spindle ( 1A ).
12. Place Planel Gear Subassembly ( 4 ) into Spindle ( 1A ) through gap between 2 Studs ( 1H ). Align
the planet gear bore with one of the planet shaft holes on the spindle ( 1A ) assembly using T-209919.
13. Insert a Planet Shaft ( 4E ) into the planet shaft hole described in Step ( 11 ) on Spindle ( 1A ). The
end of the planet shaft that does NOT have the roll pin hole should be inserted into the Spindle FIRST.
14. Now insert Planet Shaft ( 4E ) through the first set of Thrust Washers ( 4B ), Planet gear, then the sec-
ond set of Washers ( 4B ). Use an alignment punch or similar tool to align roll pin holes on
Spindle ( 1A ) and Planet Shaft ( 4E ).
N.B.-:-B
E SURE NOT TO HIT THE
P
LANET
G
EARS
( 4F )
WHEN DRIVING IN
R
OLL
P
INS
( 4G ).
15. Drive Roll Pin ( 4G ) down into the aligned roll pin holes. Pin should be flush with ODof spindle.
16. Repeat Steps ( 11 - 14) ) for the installation of the 2 remaining Planet Gears ( 4F ).
13 - Assembly- Cover
1. Grease O-Ring ( 6E ) and insert into internal groove in Cover ( 6A ).
2. Assemble Disengage Cap ( 6B ) onto Cover ( 6A ) using 2 Hex Head Bolts ( 6C ). Torque bolts to
70-80 in-lbs.
N.B.-:-N
OT NECESSARY TO REINSTALL
O-R
ING
( 6K )
UNLESS DESIRED
.
3. Insert Disengage Rod ( 6D ) into hole in Cover ( 6A ) until it touches the inside of the Disengage
Cap ( 6B ).
N.B.-:-T
HE
D
ISENGAGE
R
OD CAN BE INSERTED EITHER END FIRST
.
4. Grease Face of Thrust Washer 2 and place in Cover ( 6A ) making sure that tangs on washer seat
into pockets in cover.
5. Install O-Ring Pipe Plugs ( 6F ) into Cover ( 6A ). The plugs should be hand tight.