Secure the Long Guide Rod (20) to
18.
the Guide Block (15) using one Bolt
(16) and one Lock Nut (7).
(See Figure g.)
FIguRE g
LOng
guIdE
ROd
(20)
guIdE
BLOCK
(15)
BOLT (16)
LOCK nuT (7)
Remove the Rear Slide Wheels (27)
19.
from the Slide Base (21).
(See Assy. diagram.)
Slide the Wheel Bracket Assembly
20.
(39) into the Slide Base (21) tracks.
(See Assy. diagram.)
Re-install the Rear Slide Wheels (27)
21.
into the Slide Base (21).
(See Assy. diagram.)
Re-install the Winch’s Nylon Guide
22.
Wheel (9) located on the Front
Mounting Channel.
(See Figure B.)
Attach the Steel Cable (15A) to the
23.
Wheel Bracket Assembly (39) using
one Bolt (37), two Large Washers
(38), and one Lock Nut (7). Make
sure to route the Steel Cable over
the Nylon Guide Wheel (9) near the
Winch, and under the Slide Wheel
(44) near the Lock (40).
(See Assy. diagram.)
Electrical Installation:
Mount the Winch Solenoid Box (25A)
1.
to the left side plate of the Base
Frame (1).
(See Assy. diagram.)
To do so:
Insert two Screws (14)
•
outwards
through the two mounting holes
in the Base Frame (1). Insert one
Cable Boot (13) on each Screw. In-
sert one Lock Washer (12) on each
Screw. Then tighten the Screws
into the threaded mounting holes in
the Winch Solenoid Box (25A).
(See Assy. diagram.)
Make sure to orient the Winch Sole-
•
noid Box (25A) so that the Connec-
tor for the Winch Remote Control
(27A) faces towards the rear of the
truck. You may need to relocate
one of the mounting studs in the
Solenoid Box Assembly.
(See Assy. diagram.)
A Quick-Connect Plug is attached to
2.
the Winch Solenoid Box. Connect
this Plug to the other Quick-Connect
Plug (26A) provided and its long
wires. The long wires are attached
to the truck’s battery terminals after
completion of unit assembly.
(See Assy. diagram.)
Route the long wires (26A) from the
3.
Winch Solenoid Box (25A) to the
truck’s battery terminals. Refer to
your truck manufacturer’s recommen-
dations for routing the Cables.
(See Assy. diagram.)
Cut the long wires from the Winch
4.
Solenoid Box (26A) to length and at-
SKU 99900
For technical questions, please call 1-800-444-3353.
Page 8