Install the Large Lock Pin (50) for
21.
travel, making sure its Safety Pin is in
place.
(See Figure S.)
FIguRE S
LARgE LOCK PIn
(50)
The motorcycle should be thoroughly
22.
secured to the truck bed before trans-
porting.
Use additional tie-downs (not in-
•
cluded).
The motorcycle must be secured
•
to the truck bed at the rear and the
front for transportation.
Securing the motorcycle to the
•
Motorcyle Lift Ramp unit is only for
loading and unloading the truck,
and is not sufficient for transporta
-
tion.
unloading Instructions:
Release the tie-downs that were
1.
used to secure the motorcycle to the
truck bed. Do not yet remove the two
Straps used to secure the motorcycle
to the Large Slide Base (21).
Remove the Large Lock Pin (50).
2.
(See Figure T.)
FIguRE T
LARgE LOCK PIn
(50)
While holding the Remote Control
3.
(27A) in one hand, reel out the Steel
Cable (15A) and manually pull the
Slide Base (21) towards the rear of
the truck bed. Make sure to stand to
the side of the Slide Base, facing the
truck.
never stand behind the Slide
Base.
Maintain tension on the Steel Cable
4.
(15A) at all times. As the Slide Base
(21) moves towards the rear of the
truck bed, it will reach a point where
it pivots over the Base Frame Fixed
Wheels (18). Keeping the Steel Cable
tight, the Slide Base will descend
towards the ground in a steady man-
ner. Once the Rear Slide Wheels (27)
on the Slide Base are on the ground,
continue to reel out the Steel Cable.
Install the Small Lock Pin (51) once
5.
the Slide Base (21) has moved to the
ground and is fully down against the
end of the Base Frame (1).
(See Figure u, next page.)
SKU 99900
For technical questions, please call 1-800-444-3353
Page 13