product, but must be supplied by the
operator.
SPECIFICATIOnS
Maximum Load Capacity
1000 Pounds
Maximum Lifting Height
39”
Winch Voltage
12 VDC
Winch Cable Type and Size
Aircraft Cable
0.241” Diameter
(with Plastic Coating)
Remote Control Cord Length
14’-3”
Battery Cable Length
19’-7”
Maximum Wheel With
5-3/4”
Accessories
Tie-Down Straps (Qty.2)
unPACKIng
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
InSTALLATIOn
InSTRuCTIOnS
Read the EnTIRE IMPORTAnT
SAFETY InFORMATIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO PREvEnT
SERIOuS
InjuRY FROM ACCIdEnTAL
OPERATIOn:
Release any load from
the Motorcycle Lift before
assembling or making any
adjustments to the unit. Also
disconnect connectors from
Battery negative terminals.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
To install the unit on a truck bed will
1.
require additional manpower and a
proper lifting device (forklift, crane,
etc.).
(See Figure A.)
In these instructions, “front” means
2.
the end of the Lift Ramp closest to
the Winch (2) and truck cab. “Rear”
means the other end of the unit clos-
est to the truck tailgate.
FIguRE A
FROnT
REAR
(unIT MOunTEd
On TRuCK
SHORT BEd)
3. Position the Motorcycle Lift Ramp in
the truck bed. Make sure it is cen-
tered in the bed, midway between the
wheel wells.
Position the unit front-to-back so that
4.
the Large Slide Base (21) extends to
the ground without contacting the end
of the truck bed or tailgate.
SKU 99900
For technical questions, please call 1-800-444-3353.
Page 5