Make sure to position the mounting
9.
holes so the Rivet Nuts (57) used
will sit on a flat surface and not on
a formed face of the bed. If neces-
sary, slightly move the Motorcycle Lift
Ramp sideways to ensure the unit’s
mounting holes will be over a flat
surface.
CAuTIOn!
10.
To ensure safety, the four
mounting holes drilled in the truck bed
MUST be
17/32”
diameter.
Move the Base Frame (1) to one side
11.
to clear room to install the four Rivet
Nuts (57).
(See Figure E.)
IMPORTANT: The Rivet Nuts (57)
12.
must be installed directly on the sheet
metal truck bed with no plastic or bed
liner material between the Nut and
the metal. If necessary, cut or scrape
away the material completely in the
immediate area where the Nut will be
inserted.
(See Figure E.)
Insert a Rivet Nut (57) in each of the
13.
four truck bed mounting holes, mak-
ing sure the Nut is fully inserted and
flush with the top of the surface of the
truck bed.
(See Figure E.)
Use the provided Rivet Nut installa-
14.
tion tool according to its included in-
structions. Tighten as instructed until
each Rivet Nut (57) is tightly clamped
against the sheet metal truck bed.
(See Figure E.)
FIguRE E
RIvET nuT
(57)
Move the Base Frame (1) to align the
15.
four mounting holes in the Frame with
the four inserted Rivet Nuts (57) in the
truck bed. Secure the Base Frame
to the truck bed using four Bolts (52),
four Hex Sleeves (56), and four Flat
Washers (53).
(See Figure F.)
HEX
SLEEvE
(56)
BOLT
(52)
FLAT
WASHER
(53)
FIguRE F
Place the Slide Base (21) on the Base
16.
Frame (1) with the rear of the Slide
Base on the ground and its front lean-
ing on the end of the Fixed Wheels
(18) of the Base Frame.
(See Assy. diagram.)
Install the Long Guide Rod (20)
17.
through the Guide Pipe Support (15).
Slide the Rod down through the Sup-
port, then through the Hinged Guide,
then into the Guide Block (15) under
the Wheel Pan.
(See Figure g.)
SKU 99900
For technical questions, please call 1-800-444-3353.
Page 7