INSTALLATION
Form No. GRSDCEM1-0514
13
4. Slide each glass side panel into the upper channel, then
lower the panel into the lower channel.
Glass Side Panel Installation
5. Install the channel dividers and product divider rods.
• Position the channel dividers onto the locator pins on
the front edge and back edge of the unit.
• Place the product divider rods into the channel dividers.
The rods can be adjusted easily to separate holding
areas as needed.
Installing Product Divider Rods
NOTE: Unit must be transported in the upright position.
6. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 21° C
(70° F). avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods
and air conditioning ducts).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
Upper
Channel
Lower
Channel
Product
Divider Rod
Channel
Divider
Locator Pin
General
Glo-Ray
®
Merchandising Display Warmers are shipped with
most components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to the unit and
components enclosed.
ELECTRIC SHOCK HAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 21°C (70°F).
FIRE HAzARD: Locate unit a minimum of 25 mm (1″) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
The National Sanitation Foundation (NSF) requires that
units over 914 mm (36″) in width or weighing more than
36 kg (80 lbs.) either be sealed to or raised above the
installation surface. If unit cannot be sealed at the point of
use, 102 mm (4″) legs are included to allow for proper
cleaning access below unit.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTaNT OWNER INFORMaTION
section for
details.
2. Remove tape and protective packaging from all surfaces of
the unit.
Do not lay unit on the side with the control panel. Damage
to unit could occur.
3. Carefully lay the unit on its side
and install the four rubber feet.
• Thread a foot stud into the
hole at each corner on the
bottom of the unit. Tighten
securely.
• Slip a rubber foot over each
foot stud.
NOTE: If 102 mm (4″) legs are
required, refer to the
OPTIONS aND aCCESSORIES
section in this manual
for installation instructions. 102 mm (4″) legs are
standard on models 1041 mm (36″) and wider.
WARNING
CAUTION
NOTICE
Foot
Stud
Rubber
Foot