Hatco Glo-Ray GR2SDH-24, Инструкция по установке и эксплуатации

Страница: 18 / 24

Form No. GR2SDM-0707
16
ACCESSORIES
FLIP-UP DOOR
Doors are available for either the customer side or
the control side of the unit, and to cover single
shelves or multiple shelves of multi-tiered units.
Door(s) help keep heat in and air currents away from
the heat zone. Door(s) are not recommended for
usage on both sides or with Breath Protectors. To
install, follow these steps.
NOTE: Units 48" and larger require 2 doors per
shelf.
1. Remove the two outer screws used for mounting
the end covers. Locate the right and left hand
brackets and mount using these screws at
location A. For units 48" and larger, a center
mounting bracket is required. Usually a wire
guard screw will exist at the location of this
bracket. Remove this screw and use it to mount
center bracket, location B. If no wire guard screw
is present, it will be necessary to drill a 0.125"
diameter hole at location B. (See Figure 10.)
2. Using a flat head screw driver, remove one of the
hinge screws from the end of the aluminum hinge
on the door assembly.
3. Attach the door assembly onto the unit by
passing the unassembled hinge screw through
the hole on one of the previously installed
mounting brackets (use the center bracket if it is
being used). Then hold the door assembly in
place between the two mounting brackets, and
re-assemble the hinge screw to the aluminum
hinge through the hole in the opposite mounting
bracket. Apply Loctite, or equivalent to this screw
and reassemble. Repeat for additional door. (See
Figure 11.)
Figure 10. Flip-Up Door – Under Side View
Figure 11. Flip-Up Door – Top View
Location A
Hinge Screw
Center Bracket
Left Hand
Bracket
Right Hand
Bracket
Location B
Location A