Form No. GR2SDM-0707
12
INSTALLATION
UNPACKING
Glo-Ray
Designer
Merchandising Warmers are
shipped with most components pre-assembled.
Care should be taken when unpacking shipping
carton to avoid damage to unit and components
enclosed.
1. Remove unit from box.
2. Remove information packet.
To prevent delay in
obtaining warranty coverage, fill out and mail
in the warranty card.
3. Remove tape and protective packaging from all
surfaces of unit.
4. The unit is supplied with channel dividers and
product divider bars. First install the front and
back channel dividers over the pins. To install the
divider bars, place them in the channels provided.
(See Figure 5.) The bars can be readily adjusted
to separate your holding areas as needed.
LOCATION
NOTE: The unit must be transported in the upright
position.
For proper operation and maximum performance,
locate the
Designer
Merchandising Warmer in an
area where the ambient air temperature is constant
and is a minimum of 70° F (21° C). Areas which are
susceptible to active air movements or currents
should be avoided, i.e., near exhaust fans or hoods
and air conditioning ducts.
WARNING
For safe and proper operation, the unit must be
located 1" (25 mm) from combustible walls and
materials. If safe distances are not maintained,
discoloration or combustion could occur.
WARNINGS
To prevent any injury or damage to the unit do
not store or use gasoline or other flammable
vapors or liquids in the vicinity of this or any
other appliance.
CAUTION
Unit is not weatherproof. For safe and proper
operation the unit must be located indoors
where the ambient air temperature is a minimum
of 70°F (21°C) and a maximum of 85°F (29°C).
CAUTION
Locate the unit at the proper counter height, in
an area that is convenient for use. The location
should be level to prevent the unit or its contents
from accidentally falling, and strong enough to
support the weight of the unit and food product.
CAUTION
The National Sanitation Foundation (NSF)
requires that GR2SD Series units over 36"
(914 mm) in length or weighing more than 80 lbs.
(36 kg) to be either sealed or raised on the
installation surface. If this unit cannot be sealed
at the point of use, 4" (102 mm) legs are included
to allow for proper cleaning access below unit.
See Hatco ACCESSORIES for installation
instructions.
Figure 5. Installing Product Divider Bars
Pins
Divider Bar
Channel
Divider
Содержание Glo-Ray GR2SDH-24
Страница 21: ...Form No GR2SDM 0707 19 NOTES...
Страница 22: ...Form No GR2SDM 0707 20 NOTES...