HARVEY Gyro Air G-1000, Руководство по эксплуатации, Страница: 16 / 34

15
C3:
Re-link
C3 is the re-link button, it shows light colour in normal state. When the start/stop mode of the
machine is set up to the linkage mode, the manual start/stop operation (including the remote
control) will change the mode into manual mode on its own. Only the manual start/stop operation
is permitted at this time. The icon will flash in this area, by clicking on this C3 button, it will be
re-linked again, and the button resumes light colour.
5.1.4 Parameter Set Up area D
（
Fig. 10-4
）
Fig.10-4
D1: Back button
Click this button back to home page (main interface).
D2: Start/Stop set up
（
Fig. 10-5
）
There are two start/stop modes of the machine:
1
）
Manual start /stop mode.
2
）
linkage start/stop mode.
The dust source equipment should be connected to the Synchronous Control which is not
included. See operation instructions of the Synchronous Control (SC-800/1000). Select and
confirm the desired start/stop mode by clicking the “Start/Stop” button (Fig.10-5), then click the
D1 button back to main interface.
Fig.10-5